2001 Ford F-150 Intake Manifold 5.4L Removal Procedure :
1. Disconnect the battery ground cable (14301).
2. Relieve the fuel system pressure.
3. Drain the engine cooling system.
4. Take away the engine air cleaner (ACL)(9600) and the air cleaner outlet tube (9B659).
5. Compress and slide the hose clamp and disconnect the upper radiator hose.
6. Take away the accelerator cable snow shield. Remove the bolts. Remove the accelerator cable snow shield.
7. Disconnect the throttle body cam. Disconnect the accelerator cable (9A758). Disconnect the velocity management actuator cable. Take away the accelerator return spring.
8. Take away the accelerator cable bracket bolts and position the bracket and cables aside.
9. Disconnect the vapor management valve hose. Remove the crankcase ventilation tube and the idle air control (IAC) valve recent air tube.
10. Disconnect the exhaust gas recirculation (EGR) valve vacuum line and the main vacuum harness.
11. Disconnect the throttle place sensor electrical connector and the engine vacuum regulator electrical and vacuum connectors.
12. Disconnect the fuel pressure regulator vacuum line. Disconnect the vapor management valve vacuum line.
13. Disconnect the differential pressure feedback EGR. Take away the bolt and disconnect the brake booster vacuum line and bracket. Take away the nut.
14. Disconnect the fuel lines. Disconnect the idle air control (IAC) motor electrical connector.
15. Place the EGR valve to exhaust manifold tube aside. Disconnect the higher fitting. Loosen the lower fitting. Disconnect the 2 differential stress feedback EGR sensor hoses. Position the tube aside.
16. Remove the 4 bolts and take away the throttle physique adapter. Disconnect and remove the constructive crankcase ventilation (PCV) hose.
17. Position the ability steering reservoir aside. Remove the higher bolt. Take away the lower bolts. Place the reservoir aside.
18. Disconnect the eight gas injectors. Disconnect and take away the eight ignition coils. Take away the generator. Disconnect the heater hose.
19. Disconnect the 2 radio interference capacitors. Take away the water thermostat. Remove the 9 bolts.
20. Remove the higher intake manifold. Elevate the consumption manifold. Disconnect the intake manifold tuning valve connector. Take away the consumption manifold and discard the gaskets.
21. If required, take away the bolts and the water crossover.
